GB7RMS ~ Going Forward in 2018


A belated Happy New Year to you all 

I recognise that there has been a long gap between my last post & this one. This is due to spending much time getting the BBS, Node, and DX Cluster (all part of the FBB Linux distribution) to work and, of course the Christmas & New Year celebrations with friends and family. A busy period ~ but much fun!

In the photo above, you can see the Navico AMR1000S providing the RF link on 144.950MHz, the connected PacComm Tiny 2+ TNC (in Kiss Mode), the shack webcam atop the TNC, and the Raspberry Pi to the right of the radio/TNC.

The Pi 3 is running on a 32Gb SD card, allowing plenty of room to store the many messages that are received each day!

The learning curve, for such a capable program as FBB, has, at times, appeared steeper than vertical :-)))) It has been very challenging at times but very rewarding and much fun. I don’t regret the effort, but I do feel slightly sorry to have left you wondering when it was all going to work?

I could not have achieved this all on my own. There were several points where I just could not make something happen ~ usually because I didn’t know where a particular file or script was, and/or I was not sure how to change it. Luckily I was able to find a great mentor, Bernard F6BVP [], who lives in Paris. He was able to ‘hold my hand‘ and guide me through the difficult points, as well as telnet in when things became very puzzling, often for both of us, or just plain tricky! We both agreed that we learnt things ……… especially me! Learnt I have, that’s for sure, including keeping careful notes and a backup of the SD card!

So, after both our efforts, GB7RMS has been *fully* working since 08-01-18 ~ and what a system it is turning out to be!

Users can, if appropriate, connect to GB7RMS via RF on 144.950MHz:

  • gb7rms-1 will get them into the BBS.  [Once connected, type BBS followed by Return]
  • gb7rms-3 will get them into the DX Cluster.
  • gb7rms-9 will get them into the Node.

For users that want to use the internet, however, either on their phone, tablet or PC/Mac, then they can either use Telnet or SSH. This also means users can be drawn from further afield.  

For BBS access:

  • Telnet protocol
  • Host =
  • Port =         6300

For BBS telnet to work, each individual needs to pre-register with me so that I can set the remote flag up: name, callsign, qth, and preferred password to g0gcq [at]

For DX Cluster access:

  • Telnet protocol
  • Host =
  • Port =         7300

For Node access:

  • SSH protocol
  • Host =     
  • Password =      fpac

One of the nice things is that, when logged-in to the BBS, if you press     c     followed by [Return], you enter chat mode. You can hold quite a large group discussion, or just with a single user, the choice is yours. Good for a club net, or chatting to a friend oversees?

To exit chat mode you type        .q        followed by [Return] ………… note the fullstop before the q   🙂

There are a few other things I would like to try, over the coming months, including adding a few more nodes. I am, however, going to leave the system to run for a couple of weeks before I do any more ……… I need the break & I also want to see how it fares 🙂

There are 12 registered users for telnetting into the BBS so far & I hope to see that increase as well.

Until then ……….. enjoy!


Thanks Bernard, it was une expérience formidable!